Change a Propane Tank
Forklifts powered by propane are common inside warehouse settings. These forklifts have a propane mount situated at the rear of the driver. These tanks have to be replaced from time to time since they have limited lifespans. Forklift operators must use care when handling propane tanks. Compressed gases are dangerous, especially because the gas is flammable. Utilize care when replacing and removing propane tank to prevent being injured.
1 If there is a need to change the propane tank, the first step is to stop the forklift, then turn off the tank valve. The lift truck must be left on until the engine dies. This process burns off the gas in the transfer hose that connects the engine and the tank. Prior to taking the next steps, put on the proper safety equipment, such as insulated gloves made of either leather or neoprene. It is important for you to protect your skin from touching the compressed gas, which is extremely cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When you put in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 You could inspect for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to froth around the value. If this happens, check the valve area and the connection hose at the nut. The connecting nut must be re-tightened if you detect any leaks in the valve area, and after that do the leak checking procedure all over again. Persistent leaks mean that both the connecting hose and nut must be replaced. However, if replacing the hose and nut still does not stop the leak, the tank would have to be replaced.
4 Open the valve all the way to enable the gas to fill the connecting hose. After that you can start the forklift and continue operating.