In nearly all cases, most individuals spend quite a bit of money buying their lift truck. Hence, it is very important to take proper care of it in order to protect your investment well into the long run. It is really a great idea to know the procedures which are carried out in the care and maintenance of this piece of machine.
Amongst the best ways to tell how good the engine is working is by starting the forklift up and listening carefully to see how it works. For instance, if there are any knocks or misses, the equipment is defective and this should raise several concerns. In addition listen closely for any squealing sounds that come from the belts as these sounds will provide you with a lot of information.
Several of the main parts requiring attention during maintenance comprise the gauges, horn, safety warning devices, the lights and the overhead guard. Any faulty components or burnt out light bulbs should be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals must be cleaned when the above components have been inspected carefully. If the terminals are not clean, be sure to clean them well. Each and every battery cell must be checked in order to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters have to be replaced regularly. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Then, inspect every other component of the equipment including the wheels. If any kind of fault or issue is detected, be certain to address it immediately in order to make certain the equipment is working at its safest and optimum levels.